How to Troubleshoot Common Water Pump Problems

If you rely on a water pump to supply water to your home, it’s a good idea to know more about it. As such, we’ve prepared a guide on troubleshooting common water pump problems.

Low water pressure or sputtering faucets

One of the most basic water pump problems is low water pressure. For starters, the first thing you need to do if you have this problem immediately after installing a new water pump is to ensure you have picked the right type. Depending on your needs, the type of water pump you require differs. Of course, if that’s not an issue, then it may be an excessive amount of air in the system, clogged filters or pump valves, or a leak somewhere in your system. Almost every one of these requires professional assistance. The only relatively simple solution you can do in the meantime is to clean the clogs.

Increase in power consumption

An increase in power consumption by your water pump is just a side-effect of one of the common water pump problems: failure for the pump to turn off. The reason this happens is always a severe leak. The pump needs to continuously work to offset the demand placed on your water supply system. And because of this, it increases your power consumption. However, the only way to deal with this is to look for professional help. Finding a leak is difficult, especially if it is happening somewhere on your property where you can’t easily notice a sudden increase in dampness. It is best to turn off the water pump while you look for the leak since working continuously in this manner can damage it.

A short cycling water pump

Usually, a water pump will work for around two to five minutes to pressurize the system properly, then turn off until you open a faucet and let some of that water pressure out. Then, the cycle repeats, allowing you to have a stable level of water pressure in your pipes. However, if your water pump works on short, stuttering cycles, it is a surefire sign there’s a problem. This is almost always caused by having an inadequate air charge in the tank, too much air in the water tank, or a pipe blockage that makes it difficult for water pressure to equalize in the system. Unless you are confident you can fix the tank’s air volume control, look for professional assistance with your water pump.

The pump produces odd noises

One of the more serious water pump problems is if you notice your water pump suddenly grow louder than before. It can even start producing sounds that resemble ticking or grinding. The cause of this is a problem with the pump’s bearing, typically indicating that it has become worn. This normally won’t happen to a new water pump. But it is a risk for older models. The bearing needs to be replaced. But it’s not too difficult to learn how to do it, so it is an accessible repair. Of course, if you are looking into hiring residential movers in Denver and planning to take your water pump with you, make sure you rely on help from local experts who you know will protect your belongings since damage during transport can necessitate a complete replacement of your water pump and can produce symptoms like this, too.

Problems with water quality

There are two reasons why your water pump might be drawing dirty water. First, it’s because the muck and dirt on the bottom of the wall have been stirred up, overwhelming the filters, or the well is contaminated. In this scenario, you need to turn off the pump, clean it, and give the water time to settle while it undergoes treatment. The second option is that your pump’s filters are failing and must be quickly replaced. This, too, would require the pump to be turned off, removed, and cleaned before engaging it again. Leaving dirt in the pump system is not smart and can lead to a breakdown down the road.

The pump refuses to start

If the pump outright refuses to start, there are a couple of possible causes. First, there’s the pump’s circuit breaker, plug, and cable. However, the problem might be that the pump’s motor has burned out. This is a telltale sign that you need a new water pump since getting just a replacement motor is very rarely worth it.

Pump that is leaking water

It can be alarming to notice puddles or dripping water around or under your water pump. However, this is one of the more straightforward water pump problems and not particularly difficult to solve. It is always a sign of worn or damaged water pump seals, and you can typically find a replacement very easily. Replacing them is not hard work either on most water pump models and is something you can master with guidance.

No water in your home at all

The final water pump problem is when it looks like it’s working, yet your water seems to vanish on the way to your home. It can be tempting to blame the pump in this scenario, but you’d be wrong in nine cases out of ten. Instead, you almost certainly have a plumbing problem. A very severe one since this indicated a completely busted pipe rather than just a bad leak. After all, if no water reaches your home, the entire water pressure goes through the busted pipe. However, not all is bleak – this problem is relatively easy to notice, as you’ll most likely see a puddle forming somewhere in your yard.

A word of warning on the water pump problems

Despite now knowing how to troubleshoot common water pump problems, you might not be able to deal with them. As we hinted at throughout the text, many of the fixes to these problems require professional knowledge or even specialized tools. As such, you are almost always better off calling in a professional instead of taking the risk and damaging your pump further.

Click to rate this post!
[Total: 0 Average: 0]

WANT SOMETHING? REQUEST A QUOTE NOW!